Circuit/System Verification
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Perform the following procedure to place the control solenoid (w/body and TCM) valve assembly under the optimal conditions to test solenoid electrical DTCs.
- Ensure the transmission fluid temperature is between 50-80°C (122-176°F).
- Operate the vehicle long enough to ensure at least a 3°C (5°F) rise in TCM substrate temperature, then operate the vehicle in 4th gear for 5 seconds.
- If the DTC resets, go to Circuit/System Testing.