Repair Verification (LAT)
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Clear the DTCs.
- Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset.
- After the Conditions for Running the DTC have been met, drive the vehicle at approximately 80 kmh (50 mph) for 60 seconds.
- Perform a closed-throttle deceleration until vehicle speed is less than 40 kmh (25 mph).
- Verify with a scan tool that DTC P0420 has passed or failed this ignition cycle.
- If not passed or failed this ignition cycle, the test aborted resulting in an inconclusive test result. The above test may need to be repeated up to 5 more times during this drive cycle.