LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1702 (Engine Controls And Fuel - 3.5L - DTC P025A/P0300 To DTC P0700) >> DTC P0335 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the CKP sensor connector.
  2. Test for less than 1 ohm between low reference circuit terminal B and ground.
    • If greater than the specified value, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  3. Ignition ON, test for 4.8-5.2 volts between the 5-volt reference circuit terminal A and ground.
    • If less than the specified range, test the 5-volt reference circuit for an open/high resistance or short to ground. If the circuit tests normal, replace the ECM.
    • If greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  4. Ignition ON, test for 4.8-5.2 volts between the signal circuit terminal C and ground.
    • If less than the specified range, test the signal circuit for an open/high resistance or short to ground. If the circuit tests normal, replace the ECM.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  5. Ignition ON, engine OFF, using a jumper wire connected to ground, momentarily touch the CKP sensor signal circuit terminal C repeatedly. The CKP Active Counter parameter should increment
    • If the CKP Active Counter parameter does not increment, replace the ECM.
    • If the CKP Active Counter increments, test or replace the CKP sensor.
scientia non olet · About LEMON Manuals