Circuit/System Verification
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- If DTC P0340, P0345, P0365, or P0390 are also set, diagnose them first
- With the ignition OFF, inspect the engine wiring harnesses carrying the CMP sensor circuits for the following conditions:
- Close routing of secondary ignition components
- Close routing of aftermarket electrical equipment
- Close to solenoids, motors, and relays
- Correct any wire harness routing or component placement conditions if it is determined to be a possible source of electrical interference.
- Observe the following parameters are all incrementing:
- Exhaust CMP Bank 1 Active
- Intake CMP Bank 1 Active
- Exhaust CMP Bank 2 Active
- Intake CMP Bank 2 Active
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.