Circuit/System Testing
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the 20-way harness connector at the transmission.
- Connect the DT-47825-20 to the 20-way transmission harness connector. See Special Tools .
- Test for less than 10 ohms between the ground circuit terminals listed below and ground.
- Terminal 1
- Terminal 18
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Ignition ON, verify that a test lamp illuminates between the ignition circuit terminals listed below and ground.
- Terminal 13
- Terminal 15
- If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.
- If all circuits test normal, replace the control solenoid (w/body and TCM) valve assembly.