LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Steering Column & Steering Column Switches) >> Removal & Installation >> Ignition & Key Alarm Switch Assembly >> Removal & Installation ("C", "K", S" & "T" Series)

Removal & Installation ("C", "K", S" & "T" Series)

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2001 Pontiac Montana, 2001 Oldsmobile Silhouette, 2001 Oldsmobile Bravada, 2001 GMC Sonoma, and 2001 GMC Savana Special. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove upper and lower steering column trim covers. Disconnect steering column bulkhead connector and slide turn signal and multifunction switch connectors form bulkhead connector.
  2. Using small screwdriver, gently pry retaining clip on key alarm. Rotate alarm switch 1/4 turn, and remove alarm switch. See Fig 1. Slide ignition key and alarm switch assembly out of lock module assembly. On "C" and "K" series, use Ignition Switch Connector Release Tool (J-42759) to release ignition key alarm assembly.
  3. To install, reverse removal procedure. Tighten screws to specification. See TORQUE SPECIFICATIONS .
Fig 1: Removing Ignition & Key Alarm Switch Assembly
G95J35138Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals