Circuit/System Testing
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the transmission range switch.
- Ignition ON, verify the scan tool ECM Park/Neutral switch parameter displays In-Gear.
- If not the specified value, test the park/neutral signal circuit terminal 12 for a short to ground. If the circuit tests normal, replace the ECM.
- Install a 3A fused jumper wire between the park/neutral signal circuit terminal 12 and ground. Verify the scan tool ECM Park/Neutral switch parameter displays Park/Neutral.
- If not the specified value, test the park/neutral signal circuit for an open/high resistance. If the circuit tests normal, replace the ECM.