Conditions for Running the DTC

P0030 or P0036

• The Ignition 1 Signal parameter is between 11-18 volts.
• The engine speed is more than 400 RPM.

P0053 or P0054

• DTCs P0112, P0113, P0116, P0117, P0118, P0128, P2610 are not set.
• The ignition was OFF for more than 10 hours.
• The engine is started.
• The ECT Sensor parameter is between 0-40°C (32-104°F) at engine start-up.
• The ECT Sensor parameter minus the IAT Sensor parameter is less than 8°C (14°F) at engine start-up.
• DTCs P0053 and P0054 run once per drive cycle when the above conditions are met.

P0135

• DTCs P0116, P0117, P0118, P0128 are not set.
• The Ignition 1 Signal parameter is between 10-18 volts.
• The HO2S 1 heater duty cycle is more than 0.
• DTC P0135 runs the heater current test twice per drive cycle when the above conditions are met for 2 minutes.

P0141

• DTCs P0116, P0117, P0118, P0128 are not set.
• The ECT Sensor parameter is more than 70°C (158°F).
• The Ignition 1 Signal parameter is between 10-18 volts.
• The MAF Sensor parameter is between 5-25 g/s.
• The Engine Run Time parameter is more than 60 seconds.
• The Engine Speed parameter is between 500-3,000 RPM.
• DTC P0141 runs the heater current test twice per drive cycle when the above conditions are met for 2 seconds.