LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1694 (Engine Controls And Fuel - 2.4L - DTC P0010 To DTC P0315) >> DTC P0030, P0036, P0053, P0054, P0135, or P0141 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: You must perform the Circuit/System Verification before proceeding with Circuit/System Testing.
  1. Ignition OFF, disconnect the harness connector at the appropriate HO2S.
  2. Ignition ON, verify that a test lamp illuminates between the appropriate HO2S heater voltage supply circuit terminal D and ground.
    • If the test lamp does not illuminate, test the HO2S heater voltage supply circuit for a short to ground or an open/high resistance. If the circuit tests normal and the HO2S heater voltage supply circuit fuse is open, test all components connected to the fuse and replace as necessary.
  3. Ignition ON, verify that a test lamp does not illuminate between the appropriate HO2S voltage supply circuit terminal D and the appropriate HO2S heater low control circuit terminal listed below:
    • HO2S 1, terminal C
    • HO2S 2, terminal E
    • If the lamp illuminates, test the HO2S heater low control circuit for a short to ground. If the circuit tests normal, replace the ECM.
  4. Engine running, leave the test lamp connected from the previous step. The lamp should flash or be ON steady.
    • If the test lamp is not ON steady or flashing, test the HO2S heater low control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
    5. NOTE:
    • The output driver should detect a short to voltage and turn OFF. If a resistance fault is present the driver will remain ON and the scan tool will display more than 0.0 amp. Less than 10 ohms of resistance may set a DTC.
    • Performing this test may set additional DTCs.
  5. Ignition OFF, install a 30A fused jumper wire between the appropriate HO2S voltage supply circuit terminal D and the appropriate HO2S heater low control circuit terminal listed below:
    • HO2S 1, terminal C
    • HO2S 2, terminal E
  6. Engine running, verify the appropriate scan tool HO2S Heater parameter is less than 0.1 amp.
    • If more than the specified range, test the HO2S heater voltage supply and HO2S heater low control circuits for more than 1 ohm of resistance. If the circuits test normal, replace the ECM.
  7. If the ECM and all circuits test normal, replace the appropriate HO2S.
scientia non olet · About LEMON Manuals