Conditions for Running the DTCs

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

DTC P0030, P0031, P0032, P0050, P0051, P0052, P0130, P0131, P0132, P0135, P0150, P0151, P0152, P0155, P0300-P0306, P0341, P0342, P0343, P0366, P0367, P0368, P0443, P0458, P0459, P0496, P0497, P064D, P064E, P2096, P2097, P2098, P2099, P2195, P2196, P2197, P2198, P2231, P2234, P2237, P2240, P2243, P2247, P2297, P2298, P2626, or P2629 are not set.
The HO2S is at operating temperature.
The HO2S is between 0.75-1.25 lambda.
The engine speed is between 960-3,200 RPM.
The engine load is between 17-68 percent and steady.
The MAF is less than 8 grams.
The engine is operating in closed loop.
The long term fuel trim correction is active.
The evaporative emission (EVAP) purge is not active, or the ECM determines the EVAP hydrocarbon (HC) concentration is less than a predetermined amount when EVAP purge is active.
DTC P0133 and P0153 run continuously once the above conditions are met for greater than 10 minutes.