LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1688 (Hybrid Engine Electrical System 2.4L (Hp7)) >> Repair Instructions >> Battery Positive Cable Replacement (HP7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Route the positive battery cable the same way as originally installed.
  1. Install the positive battery cable to the vehicle and position accordingly.
    2. Fig 1: Starter Motor Electrical Connector
    GM1878823Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the positive battery cable (1) to the starter solenoid BAT stud and tighten to 15 N.m (11 lb ft).
  3. Lower the vehicle.
  4. Position the fusible link cable to the generator control module.
    5. Fig 2: Fusible Link Nut And Bolt
    GM1998501Courtesy of GENERAL MOTORS CORP.
  5. Install the following components to the generator control module.
    • Fusible link nut (1) and tighten to 10 N.m (89 lb in).
    • Fusible link bolt (2) and tighten to 10 N.m (89 lb in).
  6. Install the generator control module cover. Refer to Generator Control Module Cover Replacement .
    7. Fig 3: Positive Battery Cable Terminal Nut
    GM1999419Courtesy of GENERAL MOTORS CORP.
  7. Install the positive battery cable to the battery and tighten to 5 N.m (45 lb in).
    8. Fig 4: ECM Bracket Bolts And Nuts
    GM2030262Courtesy of GENERAL MOTORS CORP.
  8. Install the electronic control module bracket retaining nuts (1) and bolts (2) and tighten to 10 N.m (89 lb in).
  9. Connect the positive battery junction block assembly to the bracket.
  10. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (HP7) .
scientia non olet · About LEMON Manuals