LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1687 (Hybrid Controls - 3.6L (Hp5)- DTC B008A To DTC P0B3E) >> DTC B009F >> Circuit/System Testing >> DTC B009F 11, B009F 12, B009F 39, or B009F 73

DTC B009F 11, B009F 12, B009F 39, or B009F 73

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the HVCID sensor.
  2. Ignition OFF and scan tool disconnected, open and close the driver door, and wait 1 minute. Test for less than 5 Ω between the low reference circuit terminal 2 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the SDGM.
  3. Ignition ON, verify DTC P009F 39 is set.
    • If DTC is not set, test the signal circuit terminal 1 for a short to voltage or a short to ground. If the circuit tests normal, replace the SDGM.
  4. Install a 3 A fused jumper wire between the signal circuit terminal 1 and the low reference circuit terminal 2. Verify DTC P009F 12 is set.
    • If DTC is not set, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the SDGM.
  5. If all circuits test normal, test or replace the HVCID sensor.