Circuit/System Verification
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Capture and then clear the DTC information.
- Ignition OFF, wait 2 minutes.
- Ignition ON, observe the HPCMs BECM HVIC Status and HPCM HVIC Status parameters.
- The parameters should both indicate a PASS condition.
NOTE:
The HPCM must command the high voltage contactor relays closed in order for HVIC to be enabled. Fail will be displayed if any DTCs present at ignition ON prevent the HPCM from closing the high voltage contactor relays.