To Open

Opening the sunroof can be done from any position between fully closed and partially open. To open the sunroof glass, press and hold the sunroof switch to the first rearward position. This will apply the sunroof switch low reference circuit to the sunroof switch open signal circuit (12 V reference) input, pulling the reference voltage to 0 V. The constant low (0 V) input to the sunroof control module indicates an open request. Once the open request has been initiated, the sunroof control module will drive the motor in the open direction, slightly lowering the rear edge of the sunroof glass, then sliding open with the sunshade. The sunroof glass will continue to open until the sunroof motion is terminated by either:

• Motor stall is sensed because the sunroof has reached its limit of travel.
• Releasing of the sunroof switch. The sunroof may be left in any position between fully open and fully closed.