Housing O-Ring, Vent Assembly, Drain and Fill Plug Installation

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Housing O-Ring, Vent Assembly, Drain & Fill Plug Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Transfer Case O-Ring Seal
2	Transfer Case Vent Assembly Tip: Replace the vent if damaged or blocked.
3	Drain Plug CAUTION: Refer to Component Fastener Tightening Caution . Tighten: 39 N.m (29 lb ft)
4	Fill Plug Tighten: 39 N.m (29 lb ft)
5	Transfer Case Heat Shield
6	Transfer Case Heat Shield Bolts (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten: 11 N.m (97 lb in)
7	Transfer Case Bracket
8	Transfer Case Bracket Bolts (Qty: 2) Tip: Tighten the bracket bolts to light assembly torque. Tighten to specification after the transfer case is mounted in the vehicle. Refer to Fastener Tightening Specifications .