LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1672 (Engine Controls And Fuel - 3.6L (LCS) - Introduction) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: HO2S Electrical Connector
    GM1888732Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (LCS) .
  2. Disconnect the engine wiring harness electrical connector (8) from the evaporative emission (EVAP) purge solenoid.
    3. Fig 2: Chassis Fuel Feed Line Quick Connect Fitting
    GM1886167Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the chassis EVAP line quick connect fitting (1) from the EVAP canister purge solenoid valve. Refer to Plastic Collar Quick Connect Fitting Service .
    4. Fig 3: EVAP Purge Solenoid Valve Bolt
    GM1888937Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the EVAP line quick connect fitting (1) from the EVAP canister purge solenoid valve. Refer to Plastic Collar Quick Connect Fitting Service .
  5. Remove the EVAP purge solenoid bracket bolt (1).
  6. Remove the EVAP purge solenoid (3).
scientia non olet · About LEMON Manuals