LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1672 (Engine Controls And Fuel - 3.6L (LCS) - Introduction) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Intake >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Right CMP Actuator Valve - Intake
    GM1285237Courtesy of GENERAL MOTORS CORP.
  1. Inspect the CMP actuator solenoid valve seal for damage. Replace the seal if necessary.
  2. Install the CMP actuator solenoid valve.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the CMP actuator solenoid valve bolt and tighten to 10 N.m (89 lb in).
    4. Fig 2: Identifying Camshaft Position Sensor Connectors
    GM1889265Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector (2) to the bank 1 intake CMP actuator solenoid valve (5).
  5. Install the engine control module. Refer to Engine Control Module Replacement .
  6. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
scientia non olet · About LEMON Manuals