LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1669 (Automatic Transmission - 2MT70 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Instructions >> Transmission Fluid Auxiliary Cooler Outlet Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Auxiliary Cooler Inlet Pipe, Bolt, Auxiliary Cooler Outlet Pipe Nut And Auxiliary Cooler Outlet Pipe Bolt
    GM2158345Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission fluid auxiliary cooler outlet pipe (5) to the vehicle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the transmission fluid auxiliary cooler outlet pipe bolt (4) and tighten to 22 N.m (16 lb ft)
  3. Install the transmission fluid auxiliary cooler outlet pipe nut (3) and tighten to 22 N.m (16 lb ft)
  4. Install the transmission fluid auxiliary cooler inlet pipe (2).
  5. Install the transmission fluid auxiliary cooler inlet pipe bolt (1)and tighten to 22 N.m (16 lb ft).
    6. Fig 2: Auxiliary Cooler Outlet Pipe Quick Connect Fitting And Auxiliary Cooler Outlet Pipe
    GM2158346Courtesy of GENERAL MOTORS CORP.
  6. Install the transmission fluid auxiliary cooler outlet pipe (2) to the thermal bypass valve.
  7. Connect the transmission fluid auxiliary cooler outlet pipe quick connect fitting (1) at the thermal bypass valve. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection 
  8. Install the drive motor generator power inverter module support. Refer to Generator Control Module Bracket Replacement .
scientia non olet · About LEMON Manuals