Transmission Control Lever Knob Replacement

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Transmission Control Lever Knob

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Apply the parking brake. Remove the front floor console extension panel. Refer to Front Floor Console Extension Panel Replacement . Disconnect the transmission tap up/tap down switch electrical connector.
1	Automatic Transmission Control Lever Knob Bezel Tip: Removal: carefully insert a small flat-bladed tool on the right and left sides of the bezel (1) between the bezel and the shift knob. Apply careful downward pressure to the bezel to separate the bezel from the shift knob. The bezel will drop down approximately 13.0 mm (0.5 in) exposing the shift knob screw (2). Installation: Lift the bezel (1) up to the shift knob until a click sound is heard indicating the bezel is secured to the shift knob.
2	Automatic Transmission Control Lever Knob Screw (Qty: 1) CAUTION: Refer to Fastener Caution . Tip: Remove the shift control knob screw. Tighten: Tighten the screw to 1.5 N.m (13 lb in).
3	Automatic Transmission Control Lever Knob