LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1664 (Engine Controls And Fuel - 3.6L (Ly7) - Introduction) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: EVAP Purge Solenoid Valve Bolt
    GM1888937Courtesy of GENERAL MOTORS CORP.
  1. Position the EVAP purge solenoid (3) to the upper intake manifold.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the EVAP purge solenoid bracket bolt (1). Tighten the bolt to 10 N.m (89 lb in).
  3. Connect the EVAP line quick connect fitting (2) to the EVAP canister purge solenoid valve. Refer to Plastic Collar Quick Connect Fitting Service .
    4. Fig 2: Chassis Fuel Feed Line Quick Connect Fitting
    GM1886167Courtesy of GENERAL MOTORS CORP.
  4. Connect the chassis EVAP line quick connect fitting (1) to the EVAP canister purge solenoid valve. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 3: HO2S Electrical Connector
    GM1888732Courtesy of GENERAL MOTORS CORP.
  5. Connect the engine wiring harness electrical connector (4) to the EVAP purge solenoid.
  6. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (LY7) .
scientia non olet · About LEMON Manuals