LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1664 (Engine Controls And Fuel - 3.6L (Ly7) - Introduction) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Camshaft Position Actuator Solenoid Valve & Sensor Connectors
    GM1889266Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine mount bracket. Refer to Engine Mount Bracket Replacement - Right Side .
  2. Disconnect the engine wiring harness electrical connector (2) from the bank 2 intake camshaft position (CMP) actuator solenoid valve (7).
    3. Fig 2: View Of Left CMP Actuator Valve - Intake
    GM1285234Courtesy of GENERAL MOTORS CORP.
  3. Remove the CMP actuator solenoid valve bolt.
  4. Remove the CMP actuator solenoid valve.
  5. Inspect the CMP actuator solenoid valve seal for damage and replace as necessary.
scientia non olet · About LEMON Manuals