LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1664 (Engine Controls And Fuel - 3.6L (Ly7) - Introduction) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Intake >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Left CMP Actuator Valve - Intake
    GM1285234Courtesy of GENERAL MOTORS CORP.
  1. Inspect the CMP actuator solenoid valve seal for damage. Replace the seal if necessary.
  2. Install the CMP actuator solenoid valve.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the CMP actuator solenoid valve bolt. Tighten the bolt to 10 N.m (89 lb in).
    4. Fig 2: Identifying Camshaft Position Actuator Solenoid Valve & Sensor Connectors
    GM1889266Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector (2) to the bank 2 intake CMP actuator solenoid valve (7).
  5. Install the engine mount bracket. Refer to Engine Mount Bracket Replacement - Right Side .
scientia non olet · About LEMON Manuals