LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1664 (Engine Controls And Fuel - 3.6L (Ly7) - Introduction) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Camshaft Position Sensor Connectors
    GM1889265Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  2. Disconnect the engine wiring harness electrical connector (2) from the bank 1 intake camshaft position (CMP) actuator solenoid valve (5).
    3. Fig 2: View Of Right CMP Actuator Valve - Intake
    GM1285237Courtesy of GENERAL MOTORS CORP.
  3. Remove the CMP actuator solenoid valve bolt.
  4. Remove the CMP actuator solenoid valve.
  5. Inspect the CMP actuator solenoid valve seal and replace as necessary.
scientia non olet · About LEMON Manuals