LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1663 (Engine Controls And Fuel - 3.5L - Introduction) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Wiring Harness Electrical Connector
    GM1883868Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Disconnect the engine wiring harness electrical connector (1) from the evaporative emission (EVAP) canister purge solenoid (4).
    3. Fig 2: Chassis Fuel Feed Line Quick Connect Fitting
    GM1885563Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the chassis EVAP line quick connect fitting (3) from the EVAP canister purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
    4. Fig 3: View Of Upper Intake Manifold
    GM1775003Courtesy of GENERAL MOTORS CORP.
  4. Remove the EVAP canister purge solenoid bolt (1).
  5. Remove the EVAP canister purge solenoid (2) from the upper intake manifold.
  6. Remove and discard the EVAP canister purge solenoid O-ring seal (3).
scientia non olet · About LEMON Manuals