LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1663 (Engine Controls And Fuel - 3.5L - Introduction) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Upper Intake Manifold
    GM1775003Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW EVAP canister purge solenoid O-ring seal (3) to the upper intake manifold.
  2. Install the EVAP canister purge solenoid (2) to the upper intake manifold.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the EVAP canister purge solenoid bolt (1).

    Tighten:  Tighten the bolt to 16 N.m (12 lb ft).

    4. Fig 2: Chassis Fuel Feed Line Quick Connect Fitting
    GM1885563Courtesy of GENERAL MOTORS CORP.
  4. Connect the chassis EVAP line quick connect fitting (3) to the EVAP canister purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 3: Engine Wiring Harness Electrical Connector
    GM1883868Courtesy of GENERAL MOTORS CORP.
  5. Connect the engine wiring harness electrical connector (1) to the EVAP canister purge solenoid (4).
  6. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals