Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Place the ignition switch in the OFF position.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

Fig 1: BPMV Bracket Bolts

Courtesy of GENERAL MOTORS CORP.

Remove the 2 brake pressure modulator valve (BPMV) bracket bolts (1).

Fig 2: BPMV Bolt

Courtesy of GENERAL MOTORS CORP.

Remove the BPMV bolt (1).

Fig 3: BPMV Assembly

Courtesy of GENERAL MOTORS CORP.

Without disconnecting the brake pipe fittings, carefully lift the BPMV assembly (1) upward to release the mounting pins from the BPMV bracket insulators.
Do not pry on the accumulator caps on the underside of the BPMV.
Position the BPMV assembly aside and secure with heavy mechanics wire or equivalent.
Inspect the insulators for damage and replace, if necessary.