Circuit/System Testing (with HP5)
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the heater core coolant pump.
- Verify that a test lamp illuminates between the B+ circuit terminal A and ground.
- If the test lamp does not light, test the B+ circuit for a short to ground, open or high resistance. If the circuit tests normal, replace the Coolant heater pump
- Ignition ON, verify that a test lamp illuminates between the control circuit terminal B and the voltage circuit terminal A while commanding the pump ON and OFF with a scan tool.
- If the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the starter generator control module.