Component Testing
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the driver door latch assembly.
- Test for infinite resistance between the signal terminal 9 and the ground terminal 8 with the switch in the open position.
- If not the specified value, replace the door latch assembly.
- Test for less than 2.0 ohms between the signal terminal 9 and the ground terminal 8 with the switch in the closed position.
- If greater than the specified range, replace the door latch assembly.
- Test for infinite resistance between each terminal and the door latch assembly housing/case.
- If not the specified value, replace the door latch assembly.