LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1639 (Hybrid Engine Electrical System 3.6L (Hp5)) >> Repair Instructions >> Battery Current Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (HP5) .
    2. Fig 1: Current Sensor Harness Connector
    GM2107973Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the current sensor harness connector (1) from the sensor (2).
    3. Fig 2: Current Sensor & Cable
    GM2107977Courtesy of GENERAL MOTORS CORP.
  3. Remove the positive battery cable fuse fastener and cable (2) from the fuse.
  4. Remove any tape or retainers from the current sensor and cable. Note the location of the current sensor for assembly.
  5. Slide the current sensor (1) off the cable (2).
scientia non olet · About LEMON Manuals