Repair Procedures
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If you are preparing the drive motor generator battery for shipment, Install the terminal extension cover assembly and retaining bolts. Using UL® listed or equivalent insulation tape rated at a minimum of 600 V, tape over the manual disconnect opening and the HV cable openings on the terminal extension cover. Remove the drive motor battery assembly, refer to Drive Motor Generator Battery Replacement.
Perform the Diagnostic Repair Verification after completing the repair.
- Drive Motor Generator Battery Replacement
- Control Module References for drive motor generator battery control module replacement, setup and programming