Installation Procedure
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure that the marks on the camshaft position actuator and the timing chain (1-4) are aligned.
- DO NOT tighten the camshaft position actuator bolt at this time.
- Locate the camshafts to the cylinder head and assemble the camshaft actuators to the camshafts.
- Install the camshafts and the camshaft bearing caps. Refer to Camshaft Installation - Left Side (LY7) or Camshaft Installation - Left Side (LCS) .
- Remove the EN 46108 . See Special Tools .
- Install and tighten the camshaft position actuators. Refer to Camshaft Position Actuator Installation - Left Side Intake and Camshaft Position Actuator Installation - Left Side Exhaust .
- Install the intake camshaft position actuator solenoid. Refer to Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Intake .
- Install the camshaft sensors. Refer to Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust and Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake .
- Install the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
- Install the camshaft cover. Refer to Camshaft Cover Replacement - Left Side .
- Install the lower intake manifold. Refer to Lower Intake Manifold Replacement .
NOTE:
CAUTION:
Refer to Torque Reaction Against Timing Drive Chain Caution
.
NOTE:
Use an open-end wrench at the camshaft hex to prevent camshaft/engine rotation.