Valve Rocker Arm and Push Rod Installation
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Install the lower intake manifold gaskets.
- Coat the ends of the push rods using prelube GM P/N 12345501 (Canadian P/N 992704) or the equivalent.
- Install the push rods in their original location.
- Coat the rocker arm friction surfaces using prelube GM P/N 12345501 (Canadian P/N 992704) or the equivalent.
- Install the valve rocker arms in their original positions.
- Install the valve rocker arm bolts. Tighten the valve rocker arm bolts to 34 N.m (25 lb ft).
NOTE:
All gasket mating surfaces must be free of oil and foreign material. Use GM P/N 12346139 (Canadian P/N 10953463) or equivalent to clean surfaces.
NOTE:
Room temperature vulcanizing (RTV) sealer is not to be placed under the lower intake manifold gaskets.
NOTE:
The intake valve push rods measure 147.51 mm (5.81 in) and the exhaust valve push rods measure 154.87 mm (6.1 in) in length.
NOTE:
Shims (P/N 88894006) may be required under the valve rocker arm pedestals if reconditioning has been performed on the cylinder head or its components.
CAUTION:
Refer to Fastener Caution
.
NOTE:
Thoroughly clean the fastener and tapped hole prior to installation.