LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1634 (Engine Mechanical - 3.5L) >> Repair Instructions - Off Vehicle >> Valve Rocker Arm Cover Installation - Right Side

Valve Rocker Arm Cover Installation - Right Side

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Right Valve Rocker Arm Cover
    GM1557668Courtesy of GENERAL MOTORS CORP.
  1. Install NEW valve rocker arm cover grommets and use NEW valve rocker arm cover bolts if they are serviced with the grommet.
    2. NOTE: All gasket-mating surfaces need to be free of oil and foreign material. Use GM P/N 12346139 (Canadian P/N 10953463) or equivalent to clean surfaces.
  2. Install the valve rocker arm cover gasket into the valve rocker arm cover.
    3. Fig 2: Identifying Cylinder Head To Lower Intake Manifold Joint
    GM190588Courtesy of GENERAL MOTORS CORP.
  3. Apply sealer GM P/N 12378521 (Canadian P/N 88901148) or equivalent to the surfaces where the cylinder head and intake manifold meet (1).
  4. Install the valve rocker arm cover.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the valve rocker arm cover bolts, if necessary, and tighten to 10 N.m (89 lb in).
    6. Fig 3: Identifying Fresh Air Tube
    GM1557664Courtesy of GENERAL MOTORS CORP.
  6. Install the fresh air tube into the valve rocker arm cover.
    7. Fig 4: Identifying Ignition Coil Assembly, Studs & Nuts
    GM1557662Courtesy of GENERAL MOTORS CORP.
  7. Install the ignition coil assembly studs, if necessary, and tighten to 25 N.m (18 lb ft).
  8. Install the ignition coil assembly.
  9. Install the ignition coil assembly bolts and nuts and tighten to 25 N.m (18 lb ft).
scientia non olet · About LEMON Manuals