LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1634 (Engine Mechanical - 3.5L) >> Repair Instructions - Off Vehicle >> Valve Rocker Arm Cover Installation - Left Side

Valve Rocker Arm Cover Installation - Left Side

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Valve Rocker Arm Cover
    GM1821624Courtesy of GENERAL MOTORS CORP.
  1. Install NEW valve rocker arm cover grommets and use NEW valve rocker arm cover bolts if they are serviced with the grommet.
    2. NOTE: All gasket-mating surfaces need to be free of oil and foreign material. Use GM P/N 12346139 (Canadian P/N 10953463) or equivalent to clean surfaces.
  2. Install the valve rocker arm cover gasket into the valve rocker arm cover.
    3. Fig 2: Identifying Cylinder Head To Lower Intake Manifold Joint
    GM190588Courtesy of GENERAL MOTORS CORP.
  3. Apply sealer GM P/N 12378521 (Canadian P/N 88901148) or equivalent to the surfaces where the cylinder head and intake manifold meet (1).
  4. Install the valve rocker arm cover.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the valve rocker arm cover bolts, if necessary, and tighten to 10 N.m (89 lb in)
    6. Fig 3: Identifying PCV Tube O-Rings
    GM1821625Courtesy of GENERAL MOTORS CORP.
  6. Install two NEW positive crankcase ventilation (PCV) tube O-rings.
    7. Fig 4: Locating Positive Crankcase Ventilation (PCV) Valve & Tube
    GM1821628Courtesy of GENERAL MOTORS CORP.
  7. Install the fresh air tube.
scientia non olet · About LEMON Manuals