LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1634 (Engine Mechanical - 3.5L) >> Repair Instructions - Off Vehicle >> Oil Pump Assemble >> Assemble

Oil Pump Assemble: Assemble

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate all the internal oil pump parts using engine oil during assembly.
    2. Fig 1: Identifying Oil Pump Gears
    GM1557729Courtesy of GENERAL MOTORS CORP.
  2. Install the oil pump gears.
    3. Fig 2: Identifying Oil Pump Cover
    GM1557727Courtesy of GENERAL MOTORS CORP.
  3. Install the oil pump cover.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the oil pump cover bolts and tighten to 10 N.m (89 lb in).
    5. Fig 3: Identifying Oil Pump Pressure Regulator Valve
    GM1557740Courtesy of GENERAL MOTORS CORP.
  5. Install the pressure regulator valve.
  6. Install the pressure regulator spring.
  7. Install the cotter pin.
    8. NOTE: Make sure the cotter pin is properly secured.
  8. Apply sealer GM P/N 12346004, (Canadian P/N 10953480) or the equivalent to the new suction pipe.
  9. Tap the new suction pipe into place using a plastic hammer and J-22144:  Oil Suction Pipe Installer.
scientia non olet · About LEMON Manuals