Oil Pan Cleaning and Inspection

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Oil Level Sensor

Courtesy of GENERAL MOTORS CORP.

Remove the oil level sensor.
Inspect the O-ring seal (2) and the electrical connector (1) for wear or damage. Repair or replace as necessary.

Fig 2: View Of Oil Pan & Bolts

Courtesy of GENERAL MOTORS CORP.

WARNING: Bodily injury may occur if the cleaning solvent is inhaled or exposed to the skin.

Clean the oil pan with solvent. Remove all sludge and debris from the oil pan.
Dry the oil pan with compressed air.
Inspect the oil pan sealing surface for damage and replace if necessary.

Fig 3: View Of Oil Level Sensor & Bolt

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the oil level sensor and bolt and tighten to 10 N.m (89 lb in).