LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1634 (Engine Mechanical - 3.5L) >> Repair Instructions - Off Vehicle >> Cylinder Head Installation - Left Side >> Installation

Cylinder Head Installation - Left Side: Installation

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Proper Cylinder Head Gasket Installation
    GM1557858Courtesy of GENERAL MOTORS CORP.
    CAUTION: Head gaskets are specific for right hand and left hand applications, and also must be installed with the correct side facing up. Note the markings (1) on the head gaskets for proper installation. Failure to do so may lead to engine damage.
    CAUTION: This component uses torque-to-yield bolts. When servicing this component do not reuse the bolts, New torque-to-yield bolts must be installed. Reusing used torque-to-yield bolts will not provide proper bolt torque and clamp load. Failure to install NEW torque-to-yield bolts may lead to engine damage.
  1. Install the cylinder head locator dowel pins, if necessary.
  2. Inspect the cylinder head locator dowel pins for proper installation.
    3. Fig 2: View Of Cylinder Head Gasket And Alignment Pins
    GM54362Courtesy of GENERAL MOTORS CORP.
  3. Install the cylinder head gasket.
    4. Fig 3: Removing/Installing Cylinder Head
    GM1369266Courtesy of GENERAL MOTORS CORP.
  4. Install the cylinder head.
    5. Fig 4: View Of Cylinder Head Bolt Tightening Sequence
    GM826677Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  5. Install the new cylinder head bolts and tighten to:
    1. Tighten the cylinder head bolts a first pass in sequence to 60 N.m (44 lb ft) .
    2. Tighten the cylinder head bolts a final pass in sequence to 95 degrees using the J 45059:  meter .
scientia non olet · About LEMON Manuals