LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1634 (Engine Mechanical - 3.5L) >> Repair Instructions - Off Vehicle >> Camshaft Bearing Installation >> Installation

Camshaft Bearing Installation: Installation

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Camshaft Bearing Service Set
    GM622704Courtesy of GENERAL MOTORS CORP.
  1. Assemble the J-33049:  Camshaft Bearing Service Set according to the manufacturer's instructions.
    2. Fig 2: Removing/Installation Camshaft Inner Bearing Using J 33049
    GM4985Courtesy of GENERAL MOTORS CORP.
    CAUTION: Severe engine damage may result if the oil holes are not correctly aligned.
  2. Install the camshaft bearings in the following order:
    1. Index the camshaft bearing oil holes with the engine block oil passages.
    2. Place the bearing on the J-33049:  Service Set .
    3. Install the third camshaft bearing.
    4. Install the second camshaft bearing.
    5. Install the outer camshaft bearings.
    3. Fig 3: Identifying Camshaft Rear Bearing Hole Plug Installation Depth
    GM187008Courtesy of GENERAL MOTORS CORP.
  3. Apply sealer GM P/N 12377901 (Canadian P/N 10953504) or the equivalent to the camshaft rear bearing hole plug.
  4. Install the camshaft rear bearing hole plug.
scientia non olet · About LEMON Manuals