LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1632 (Power Steering System) >> Diagnostic Information and Procedures >> Rattle, Clunk, or Shudder Noise from the Power Steering System (with HPS)

Rattle, Clunk, or Shudder Noise from the Power Steering System (with HPS)

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Step Action Yes No
1 Did you review the Power Steering System General Description and perform the necessary inspections? Go to Step 2  Go to Symptoms - Power Steering System (with HPS)  or Symptoms - Power Steering System (with EPS) 
2 Verify that a rattle, clunk or shudder noise is present.
Is a rattle, clunk or shudder noise present?
Go to Step 3  System OK
3 Inspect the power steering hoses for proper routing and clearance.
Is the routing or clearance of the power steering hoses incorrect?
Go to Step 11  Go to Step 4 
4 Inspect the drive belt for cracking or excessive wear. Refer to Drive Belt Falls Off and Excessive Wear Diagnosis .
Is the drive belt cracked or excessively worn?
Go to Step 12  Go to Step 5 
5 Inspect the power steering pump pulley for damage.
Is the power steering pump pulley damaged?
Go to Step 13  Go to Step 6 
6 Inspect the power steering pump and the power steering pump mounting bracket/brace for the proper installation. Refer to Power Steering Pump Replacement (LY7)  or Power Steering Pump Replacement (LZ4)  or Power Steering Pump Replacement (LE5) .
Is the power steering pump installation incorrect?
Go to Step 14  Go to Step 7 
7 Inspect the steering gear for the proper installation. Refer to Steering Gear Replacement (HP5)  or Steering Gear Replacement (NJ1 or HP7)  or Steering Gear Replacement (NVH) .
Is the steering gear installation incorrect?
Go to Step 15  Go to Step 8 
8 Inspect for looseness in the steering linkage inner and outer tie rods.
Did you find looseness in the tie rods?
Go to Step 16  Go to Step 9 
9 Inspect the suspension.
Is the suspension worn?
Go to Step 17  Go to Step 10 
10 Inspect the steering shaft coupling.
Is the steering shaft coupling worn?
Go to Step 18  Go to Step 3 
11 Adjust or replace the hoses. Refer to the appropriate procedure(s):
Did you complete the repair?
Go to Step 19  -
12 Replace the engine drive belt. Refer to Drive Belt Replacement (LE5) or Drive Belt Replacement (LAT) .
Did you complete the repair?
Go to Step 19  -
13 Replace the power steering pump pulley. Refer to Power Steering Pump Pulley Replacement (LY7)  or Power Steering Pump Pulley Replacement (LZ4)  or Power Steering Pump Pulley Replacement (LE5) .
Did you complete the repair?
Go to Step 19  -
14 Install the power steering pump correctly. Refer to Power Steering Pump Replacement (LY7)  or Power Steering Pump Replacement (LZ4)  or Power Steering Pump Replacement (LE5) .
Did you complete the repair?
Go to Step 19  -
15 Install the power steering gear correctly. Refer to Steering Gear Replacement (HP5)  or Steering Gear Replacement (NJ1 or HP7)  or Steering Gear Replacement (NVH) .
Did you complete the repair?
Go to Step 19  -
16 Replace the necessary steering linkage tie rod.
Did you complete the repair?
Go to Step 19  -
17 Replace the worn suspension components. Refer to Diagnostic Starting Point - Suspension General Diagnosis .
Did you complete the repair?
Go to Step 19  -
18 Replace the steering shaft coupling. Refer to Steering Shaft Coupling Replacement .
Did you complete the repair?
Go to Step 19  -
19 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3