LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1629 (Engine Mechanical - 2.4L) >> Repair Instructions - On Vehicle >> Powertrain Mount Balance - Lower Mount

Powertrain Mount Balance - Lower Mount

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Follow the balance procedure steps listed below. Powertrain mounts must be tightened in sequence.
    Fig 1: Front Transaxle Mount And Through Bolt
    GM1810098Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Loosen the front transaxle mount through bolt.
    3. Fig 2: Rear Transaxle Mount And Through Bolt
    GM1810114Courtesy of GENERAL MOTORS CORP.
  3. Loosen the rear transaxle mount through bolt.
  4. Shake the powertrain vigorously from front to rear and allow the powertrain to settle.
    5. Fig 3: Rear Transaxle Mount And Through Bolt
    GM1810114Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  5. Tighten the rear transaxle mount through bolt to 100 N.m (74 lb ft).
    6. Fig 4: Front Transaxle Mount And Through Bolt
    GM1810098Courtesy of GENERAL MOTORS CORP.
  6. Tighten the front transaxle mount through bolt to 100 N.m (74 lb ft).
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals