LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1629 (Engine Mechanical - 2.4L) >> Repair Instructions - On Vehicle >> Oil Pan Replacement (LE5) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Oil Pan
    GM1578310Courtesy of GENERAL MOTORS CORP.
  1. Ensure that the oil pan and the sealing surface on the lower crankcase are free of all oil and debris.
  2. Apply a 2 mm bead of sealant (1) around the perimeter of the oil pan and the oil suction port opening. DO NOT over apply the sealant. More than a 2 mm bead is not required. Refer to Adhesives, Fluids, Lubricants, and Sealers  for the correct part number.
  3. Install the oil pan.
    4. Fig 2: Identifying Oil Pan Bolts
    GM1578309Courtesy of GENERAL MOTORS CORP.
  4. Install the oil pan bolts.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the 4 oil pan to transaxle bolts (1) and tighten to 75 N.m (55 lb ft).
    6. Fig 3: Identifying Oil Pan Bolts Removal & Tightening Sequence
    GM466580Courtesy of GENERAL MOTORS CORP.
  6. Tighten the oil pan bolts in the sequence shown to 25 N.m (18 lb ft).
  7. Install the lower AC compressor bolt.
  8. Install the engine drive belt. Refer to Drive Belt Replacement (LE5) .
  9. Lower the vehicle.
  10. Fill the engine oil to the proper level.
scientia non olet · About LEMON Manuals