LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1629 (Engine Mechanical - 2.4L) >> Repair Instructions - On Vehicle >> Crankshaft Balancer Replacement (LAT) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Crankshaft Balancer And Bolt
    GM1811400Courtesy of GENERAL MOTORS CORP.
  1. Position the crankshaft balancer.
  2. Install a NEW crankshaft balancer bolt.
    3. Fig 2: Holding Balancer Using Special Tool
    GM1820840Courtesy of GENERAL MOTORS CORP.
  3. Install the J 38122-A  (1), and a breaker bar to the balancer in order to prevent the balancer from rotating while tightening the bolt. See Special Tools .
    4. CAUTION: Refer to Fastener Caution .
  4. Tighten the crankshaft balancer bolt. Tighten the bolt to 100 N.m (74 lb ft) plus an additional 125 degrees using the J 45059  . See Special Tools .
  5. Install the engine splash shield.
  6. Install the drive belt. Refer to Drive Belt Replacement (LAT) .
scientia non olet · About LEMON Manuals