Circuit/System Testing
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the fuel door release actuator.
- Connect a test lamp between control circuit terminal A and control circuit terminal B.
- Ignition ON, command the door locks to LOCK and UNLOCK by using the driver door lock switch. The test lamp should illuminate while commanding the LOCK and UNLOCK states.
- If the test lamp is always ON, test both control circuits for a short to voltage.
- If the test lamp remains OFF, test both control circuits for a short to ground or open/high resistance.
- If all circuits test normal, test or replace the fuel door release actuator.