Component Testing
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the driver door lock switch.
- Test for infinite resistance between the signal terminals 3 and 1 and the ground terminal 2 with the switch in the open position.
- If less than the specified value, replace the driver door lock switch.
- Test for less than 2 ohms between the signal terminal 3 and the ground terminal 2 with the switch in the unlock position.
- If greater than the specified range, replace the driver door lock switch.
- Test for less than 2 ohms between the signal terminal 1 and the ground terminal 2 with the switch in the lock position.
- If greater than the specified range, replace the driver door lock switch.