LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1621 (Steering Wheel And Steering Column) >> Repair Instructions >> Steering Angle Sensor Replacement (NVH) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Steering Angle Sensor
    GM1768910Courtesy of GENERAL MOTORS CORP.
  1. Slide the steering angle sensor up the steering column shaft until the sensor is on the retaining bracket slot.
  2. Install the steering angle sensor into the groove of the retaining bracket.
  3. Connect the connector to the steering angle sensor.
    4. Fig 2: Upper Pinch Bolt
    GM1768734Courtesy of GENERAL MOTORS CORP.
    NOTE: Ensure the steering wheel is in the straight-ahead position.
  4. Align the match marks and carefully guide the steering shaft coupling onto steering column shaft.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the pinch bolt into the steering shaft coupling and tighten to 30 N.m (22 lb ft).
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  7. Perform the steering angle sensor centering procedure. Refer to Steering Angle Sensor Centering .
scientia non olet · About LEMON Manuals