Torque Converter Removal
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Lock Pin
WARNING:
Lock pin must be secured into the bench fixture to hold the transmission and prevent bodily injury. Tip: Ensure the J 3289-20: holding fixture is mounted to a bench that is properly supported and will support the weight of the transmission assembly without tipping. J-39890: holding fixture adapter adapter and an engine stand can be used as an alternative method for supporting the transmission assembly during repairs. Special Tools
For equivalent regional tools, refer to Special Tools . |
| 2 | J 21366:
Converter Holding Strap For equivalent regional tools, refer to Special Tools . |
| 3 | Dust Cover Bolts M10 x 25, model dependent (Qty: 2) |
| 4 | Dust Cover Push Pin, model dependant |
| 5 | Dust Cover, model dependant |
| 6 | Torque Converter Assembly
CAUTION:
Only install the lift assist handles until it stops. Do not tighten. Over tightening the lift assist handles can cause damage to the torque converter. Tip: Failure to raise the torque converter straight up could damage the torque converter clutch lip seal inside the torque converter clutch assembly. Special Tools: J 46409: Torque Converter Lifting Handles For equivalent regional tools, refer to Special Tools . |