LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1620 (Automatic Transmission - 6T75 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Instructions >> Front Differential Drive Pinion Gear Bearing Cup and Lubricant Dam Replacement >> Removal

Front Differential Drive Pinion Gear Bearing Cup and Lubricant Dam Replacement: Removal

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Front Differential Drive Pinion Gear Bearing Cup & Lube Dam
GM1737815Courtesy of GENERAL MOTORS CORP.
Removal

Callout Component Name
1 Front Differential Drive Pinion Gear Bearing Cup
CAUTION: Failure to apply the lubricant will cause damage to the bolt and nut threads.

Tip: 
  • Tighten J-45094:  cup remover until it fits snugly on the bearing cup.
  • Adjust J 45124:  removal bridge so it sits on the case surface just beyond the bearing cup opening.
  • Apply the extreme pressure lubricant J 23444-A:  extreme press lubricant to the puller bolt threads to prevent damage to the bolt threads during bearing cup removal.
  • Hold the puller bridge nut and turn the bolt to remove the bearing cup.

Special Tools

  • J 23444-A:  Extreme Press Lubricant - 1/4 Ounce Tube
  • J-45094:  Bearing Cup Remover
  • J 45124:  Removal Bridge

For equivalent regional tools, refer to Special Tools .
2 Front Differential Drive Pinion Gear Lube Dam

Special Tools

  • J 6125-1B:  Slide Hammer with Adapter
  • DT-48055:  Lube Dam Removal

For equivalent regional tools, refer to Special Tools .
scientia non olet · About LEMON Manuals