Piston and Reluctor Wheel Installation

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Piston And Reluctor Wheel

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	3-5 Reverse Clutch Piston Dam Seal
2	3-5 Reverse Clutch Piston Inner Seal (Black) Tip: Apply a thin coat of ATF to the seal to ease the installation of the piston.
3	3-5 Reverse Clutch Piston Inner Seal (Orange) Tip: Apply a thin coat of ATF to the seal to ease the installation of the piston.
4	3-5 Reverse Clutch Spring Assembly
5	3-5 Reverse Clutch Piston Tip: J-46622: seal protector prevents the piston seal lip from damage during installation. Apply a thin coat of ATF to the I.D. of J-46622: seal protector to ease the installation of the piston. Install J-46622: seal protector onto the speed sensor reluctor wheel. Push the 3-5 Reverse Clutch piston into the reluctor wheel until it stops against J-46622: seal protector. Remove J-46622: seal protector by separating it at the opening. Special Tools: J-46622: Piston Seal Protector For equivalent regional tools, refer to Special Tools .
6	A/Trans Input Shaft Speed Sensor Reluctor Wheel
7	A/Trans Input Shaft Speed Sensor Reluctor Wheel Retaining Ring CAUTION: Compress the reluctor wheel just enough to clear the retainer ring groove. Over compressing the reluctor wheel will break the alignment tab and the clutch housing. Special Tools: DT-47694: Piston Spring Compressor For equivalent regional tools, refer to Special Tools .