Park/Neutral Position Switch Adjustment: Adjustment

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Shift Control Cable, Lever & Electrical Connector At Transaxle Range (TR) Switch

Courtesy of GENERAL MOTORS CORP.

Disconnect the transaxle range switch electrical connectors from the switch.
Remove the shift control cable from the transaxle range switch lever.

Fig 2: Identifying Transaxle Range (PNP) Switch Lever

Courtesy of GENERAL MOTORS CORP.

Remove the transaxle range switch lever and nut

Fig 3: Identifying Transaxle Range Switch And Mounting Bolts

Courtesy of GENERAL MOTORS CORP.

Make sure the transaxle manual shaft is in the Neutral position.
Loosen, DO NOT REMOVE the transaxle range switch bolts.

Fig 4: Identifying J 41545

Courtesy of GENERAL MOTORS CORP.

Insert the J 41545 as shown and rotate the switch until the tool drops onto position. See Special Tools .

CAUTION: Refer to Fastener Caution .

Tighten the transaxle range switch bolts to 20 N.m (15 lb ft).
Remove the alignment tool.

Fig 5: Identifying Transaxle Range (PNP) Switch Lever

Courtesy of GENERAL MOTORS CORP.

NOTE: After adjusting the switch, verify the engine only starts in Park or Neutral. If the engine starts in any other position, adjust the switch.

Install the transaxle range switch lever and nut and tighten to 35 N.m (26 lb ft)

Fig 6: Identifying Shift Control Cable, Lever & Electrical Connector At Transaxle Range (TR) Switch

Courtesy of GENERAL MOTORS CORP.

Connect the transaxle range switch electrical connectors to the switch.
Install the shift control cable to transaxle range switch lever and verify proper operation.