Installation Procedure
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Install the eight lo and the reverse band oil pipe assembly seals.
- Install the lo and the reverse band oil feed pipe assembly onto the transmission.
- Hand start the bolts that attach the oil feed pipe assembly to the transmission.
Tighten the bolts to 12 N.m (106 lb in).
- Install the transmission oil filter assembly. Refer to Automatic Transmission Fluid Filter and Seal Replacement .
- Reset the TAP values. Refer to Transmission Adaptive Functions .
CAUTION:
Refer to Fastener Caution
.
NOTE:
It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the engine control module (ECM), powertrain control module (PCM) or transmission control module (TCM) will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the engine control module (ECM), powertrain control module (PCM) or transmission control module (TCM) will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.